Adjusting Alignment Sensors - OEM VKP80III User Manual

4. OPERATION

4.2 Adjusting alignment sensors

Printer is provided with a mobile sensor for the detection of alignment notch placed on the non-thermal side of paper
(located lower than the plane of the paper inside the printer).
The device user will need to manually move this mobile sensor according to the position of the notch on the paper
(see next sections).
To use this sensor for notch detection, you must set the "Notch/B.Mark Position" setup parameter on the "Bottom"
value (see Chapter 5).
THERMAL SIDE
NON-THERMAL SIDE
24 VKP80III
User Manual
MOBILE SENSOR FOR NOTCH
("Notch/B.Mark Position" = "Bottom")