Printer Parameters - OEM KPM216HII User Manual

5.4 Printer parameters

This printer allows the confi guration of the parameters listed in the following table.
The parameters marked with the symbol
Settings remain active even after the printer has been turned off and they are stored in non-volatile memory.
RS232 BAUD RATE
RS232 DATA LENGTH
RS232 PARITY
RS232 HANDSHAKING
BUSY CONDITION
USB ADDRESS NUMBER Numerical address code for the univocal identifi cation of the USB device (in case of
USB STATUS MONITOR
D are the default values.
Communication speed of the serial interface:
230400 9600
D
115200 4800
57600 2400
38400 1200
19200
NOTE: Parameter valid only with serial interface.
Number of bit used for characters encoding:
7 bits/car
D
8 bits/car
NOTE: Parameter valid only with serial interface.
Bit for the parity control of the serial interface:
D
None = parity bit omitted
Even = even value for parity bit
Odd = odd value for parity bit
NOTE: Parameter valid only with serial interface.
Handshaking:
D
XON/XOFF = software handshaking
Hardware = hardware handshaking (CTS/RTS)
NOTE: Parameter valid only with serial interface.
NOTE: When the receive buffer is full, if handshaking is set to XON/XOFF, the printer sends the XOFF
($13) on the serial port. When the receive buffer has cleared once again, if handshaking is set to XON/
XOFF, the printer sends the XON ($11) on the serial port.
Activation mode for Busy signal:
OffLine/ RXFull = Busy signal is activated when the printer is both in OffLine status
and the buffer is full
RXFull D = Busy signal is activated when the buffer is full
NOTE: Parameter valid only with serial interface.
more than a USB device connected with the same PC):
D
0 4 8
1 5 9
2 6
3 7
Status monitoring of the printer using an additional printer driver (Status Monitor).
It must be enabled only if the specifi c driver with status monitor has been installed:
D
Disabled = monitoring the status of the printer driver is not performed
Enabled = monitoring the status of the printer driver is performed
5. CONFIGURATION
KPM216HII 41
User manual