OEM VKP80III User Manual page 89

To set a negative value of the "Notch Distance" parameter is useful in cases where the alignment point refers to the
notch printed on the previous ticket. In the following images, the value of "Notch Distance" parameter is set to -A.
Notch front
The following fi gure shows a section of the device with the paper path and the distances between the alignment sen-
sors, the printing head and the cutter (cutting line), where
A = 11.9mm = distance between the cutting line (cutter) and the printing line (head) on paper
B = 15.3mm = distance between the the printing line (head) and the mobile alignment sensors (bottom)
C = 11.8mm = distance between the mobile alignment sensor (bottom) and the upper alignment sensor (only for
models with left upper sensor or right upper sensor)
- A
Alignment point
0
10. ALIGNMENT
PRINTING DIRECTION
VKP80III 89
User Manual