Bus Connector 6Es7 972-0B.10-0Xa0 - Siemens simatic c7-621 Hardware Installation Manual

3.5.3

Bus Connector 6ES7 972-0B.10-0XA0

Appearance
Table 3-6 shows the bus connector 6ES7 972-0B.10-0XA0
Table 3-6 Description and Functions of the Bus Connector 6ES7 972-0B.10-0XA0
Front View of the Bus Connector
With PG Interface
Preparing the
To connect the bus connector 6ES7 972-0B.10-0XA0 to the PROFIBUS LAN
PROFIBUS LAN
cable, follow the steps outlined below:
Cable for the Bus
1. Cut the bus cable to the required length
Connector
2. Strip the insulation from the bus cable as shown in Figure 3-12.
Figure 3-12
3. Open the housing of the bus connector by undoing the screws in the
4. Remove the cover.
C7-621 / C7-621 AS-i Control Systems
C79000-G7076-C621-01
Without PG Interface
6XV1 830–0AH10/-3BH10
7.5 9
Ç Ç
Ç Ç
6
Preparing the LAN Cable for Connecting the Bus Connector
6ES7 972-0B.10-0XA0
housing.
Configuring an MPI Network
No. Function
Connection to
the MPI,
PROFIBUS DP
interface (9-pin
sub D connector)
Connector for
the PROFIBUS
LAN cable
Terminating
resistor
Interface for
PG/OP
Screws for fixing
to the node
6XV1 830–3AH10
7.5 9
Ç Ç
Ç Ç
16 6
3-17