OREC GRH537Pro Owner's Manual page 14

■ Install the Handle
NUT SET,
H
HANDLE BRACE (M8)
■ Install the Front Bumper
B
NUTS, WASHER
(M8)
FRONT BUNPER
B
BOLTS (M8)
■ Install the Side Plates
S
NUT, SIDE PLATE
SIDE PLATE (L)
SIDE PLATE (R)
■ Assemble Grass Bag
PLASTIC EDGE
BAG FRAME
HANDLE SETTING BOLT
(M8X35)
MINI HEX. BOLT
(M8X25)
HOOK
BOLT, SIDE PLATE
REAR GUARD
1.
Insert the Hex. Bolt(M8x25) in to the
HANDLE BRACE
deck the inside. Slide handle brace
on to hex. bolt
2. Hook the Handle pin into the hole at the
Handle Brace.Insert the Handle Setting
HOLE
Bolt(M8x35) through the Handle and
Handle Brace.
3.
Fix all bolts using Nut set (H) and
H
10/12mm wrench
1.
Insert the Bolt(B) in to the Front Bumper
from the bottom. Slide bolts through
the holes in attachment plate
2. Attach nuts and washers to bolts
on the attachiment plate.
3.
Tighten the bolts and nuts.
1.
Place the Side Plate(L) and Side Plate(R )
inside of Rear Guard
2. Insert the Bolts(S) from inside out.
Attach nut(S)on the other side.
3.
Tighten the bolts and nuts
1. Insert the Bag Frame into the Grass Bag
as shown at left
2.
Push each point into the plastic edge
of the Grass Bag
14