Clutch Installation - Sym PA12B Service Manual

4 、 Lubrication / Clutch / Transmission
Clutch plate inspection
Use a feeler gauge to measure the warp of
each clutch plate.
Service limit：under 0.2mm
Clutch outer inspection
Check the clutch outer to see if any cracks or
damage can be found.

Clutch Installation

Install the clutch outer and the 20mm washer.
Caution
You can slightly rotate or sway the 20mm
washer to make it fit into the main shaft
groove.
Install the clutch pressing plate, friction disks,
clutch plates, and the clutch center. Then
install the 20mm holding ring.
4-14
To this chapter contents
Holding Ring
Washer