Brake Lamp Switch/Starting Inhibitor Switch; Headlamp Beam Distance; Clutch Disc Wear - Sym Joyride125 Service Manual

2. MAINTENANCE INFORMATION
Remove brake lining bolt.
Take out the lining.
Caution
In order to maintain brake power balance,
the brake lining must be replaced with one
set.
BRAKE LAMP SWITCH/STARTING
INHIBITOR SWITCH
The brake lamp switch is to light up brake lamp
as brake applied.
Make sure that electrical starter can be operated
only under brake applying.

HEADLAMP BEAM DISTANCE

Turn on main switch
Headlamp beam adjustment. Turn the headlamp
adjustment screw with driver to adjust headlamp
beam high.
Caution
To adjust the headlamp beam follows related
regulations.
Warning
Improper headlamp beam adjustment will
make in coming driver dazzled or insufficient
lighting.

CLUTCH DISC WEAR

Run the motorcycle and increase throttle valve
opening gradually to check clutch operation.
If the motorcycle is in forward moving and
shaking, check clutch disc condition. Replace it
if necessary.
2-10
Lining
Adjust screw
To this chapter contents
Lining bolt
Master
cylinder
Brake switch