To this chapter contents
8. Cylinder / Piston
Cylinder Inspection
Check if the inner diameter of cylinder is worn
Exhaust side
Inlet side
out or damaged.
Measure the cylinder inner diameter in X and
Top
Y axis at three levels.
Service limit:37.50 mm
Center
Calculate the taper and out of round at three
levels in X and Y axis. Take the maximum
Bottom
value to determine.
Service limit:
Out of round:0.05 mm
Taper:0.05 mm
Measure the cylinder upper surface for
warpage.
Service limit:0.05mm
8-4