Brake Caliper - Sym PA12B Service Manual

Brake Caliper

Removal
Place a container under the brake caliper, and
loosen the brake hose bolt and remove the
brake hose.
Caution
Do not spill brake fluid on painted
surfaces.
Remove two caliper bolts and the caliper.
Confirm the brake pad wear condition.
Replace with new brake pad if wear limit is
reached.
Installation
Install the caliper and tighten the bolts.
Torque value：3.1~3.5kgf-m
Caution
Use M8 x 32 mm flange bolt only.
Long bolt will impair the operation of
brake disk.
Use two seal washers and hose bolts to lock
the hose and brake caliper in place.
Torque value：3.3~3.7kgf-m
Fill the brake fluid to the reservoir and make
necessary air bleeding.
To this chapter contents
Brake hose bolt
10. Brake System
Wear limit groove
Seal washer
Bolt×2
10-7