Brake Light Switch/Starting Inhibitor; Switch; Headlight Beam Distance; Clutch Disc Wear - Sym HD 125 Service Manual

2. MAINTENANCE INFORMATION
Make sure the brake lining condition. Replace
the lining if the brake lining wear limitation groove
close to the brake disc.
Brake Lining Replacement
Compress the caliper and let the brake lining out
of the caliper mounting plate. Compress the brake
lining locking spring. Remove the inner brake
lining firstly and then remove the outer brake
lining.
Compress the brake caliper at first as installation.
Install the inner brake lining firstly, and then install
the outer brake lining.
Caution
In order to maintain brake power balance, the
brake lining must be replaced with one set.

Brake Light Switch/Starting Inhibitor

Switch

The brake lamp switch is to light up brake lamp as
brake applied.
Make sure that electrical starter can be operated
only under brake applying.

Headlight Beam Distance

Turn on main switch
Headlight beam adjustment. Turn the headlight
adjustment screw to adjust headlight beam high.
Caution
To adjust the headlight beam follows related
regulations.
Improper headlight beam adjustment will
make in coming driver dazzled or insufficient
lighting.

Clutch Disc Wear

Run the motorcycle and increase throttle valve
opening gradually to check clutch operation.
If the motorcycle is in forward moving and shaking,
check clutch disc condition. Replace it
2-10
To this chapter contents
Lining
Brake switch
Adjust screw
Clutch weight
Brake lining wear
limitation groove
Master cylinder
Drive plate