MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM
Handlebar side
a. Loosen the locknut "1".
b. Adjust the play of throttle cable by turning the
adjusting nut "2" in direction "a" or "b".
Direction "a"
Increases the throttle cable play.
Direction "b"
Decreases the throttle cable play.
c. Tighten the locknut.
1
2
b
a
EWA12920
WARNING
After adjusting the throttle cable free play,
start the engine and turn the handlebars to
the right and to the left to ensure that this
does not cause the engine idling speed to
change.
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
EAS20690
CHECKING THE SPARK PLUG
1. Disconnect:
Spark plug cap
G
2. Remove:
Spark plug
G
ECA13330
CAUTION:
Before removing the spark plug, blow away
any dirt accumulated in the spark plug well
with compressed air to prevent it from falling
into the cylinder.
3. Check:
Spark plug type
G
Incorrect → Change.
Manufacturer/model
NGK/DR7EA
4. Check:
Electrode "1"
G
Damage/wear → Replace the spark plug.
Insulator "2"
G
Abnormal color → Replace the spark plug.
Normal color is medium-to-light tan.
5. Clean:
Spark plug
G
(with a spark plug cleaner or wire brush)
6. Measure:
Spark plug gap "a"
G
(with a wire thickness gauge)
Out of specification → Regap.
Spark plug gap
0.6–0.7 mm (0.024–0.028 in)
7. Install:
Spark plug
G
Spark plug
18 Nm (1.8 m•kg, 13 ft•lb)
NOTE:
Before installing the spark plug, clean the spark
plug and gasket surface.
8. Connect:
Spark plug cap
G
EAS20700
CHECKING THE IGNITION TIMING
NOTE:
Before checking the ignition timing, check the
wiring connections of the entire ignition system.
Make sure all connections are tight and free of
corrosion.
1. Remove:
Timing mark accessing screw "1"
G
3-8
ENGINE