Yamaha XT250X Service Manual page 121

c. Clean the excessive rubber adhesive with a
clean cloth. rubber adhesive
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
1. Install:
Left handlebar switch "1"
G
NOTE:
Align tab "a" of special washer with slot "b" of
G
left handlebar switch.
Align the matching surface of left handlebar
G
switch with mark "c" of the handlebar.
a
b
2. Install:
Clutch lever assembly "1"
G
Clutch lever holder "2"
G
NOTE:
Align the mating surfaces of the clutch lever
holder with the punch mark "a" on the handlebar.
3. Install:
Throttle grip "1"
G
Throttle cables "2"
G
Throttle cable housing "3"
G
EWA13720
WARNING
Make sure the throttle grip operates smooth-
ly.
NOTE:
Align projection "a" of slot cable housing with
G
hole "b" of the handlebar.
1
c
1
a
2
Slightly coat the end of slot cable and inside of
G
throttle grip with Yamaha Grease B. Then,
mount the throttle grip onto the handlebar.
2
4. Install:
Right handlebar switch "1"
G
NOTE:
Align projection "a" of the right handlebar switch
with hole "b" of the handlebar.
b
5. Install:
Front brake master cylinder assembly "1"
G
Front brake master cylinder holder "2"
G
Front brake master cylinder as-
sembly
7 Nm (0.7 m•kg, 5.1 ft•lb)
NOTE:
Install the brake master cylinder holder with the
G
"UP" mark facing up.
Align the matching surface of brake master cyl-
G
inder holder with mark "a" of handlebar.
Tighten the upper bolt first, and then tighten
G
the lower bolt.
4-37
HANDLEBAR
3
a 1
b
1
a