8. Install:
Pressure plate
G
Adjusting screw
G
Pressure plate
G
Clutch springs
G
NOTE:
Tighten the clutch spring bolts in two stages and
in a crisscross pattern.
Adjusting screw lock nut
8 Nm (0.8 m•kg, 5.8 ft•lb)
Clutch spring bolt
8 Nm (0.8 m•kg, 5.8 ft•lb)
9. Check:
Push lever position
G
Push lever mark "a" and crankcase mark "b"
not aligned → Correct.
NOTE:
Move the push lever in the arrow direction with
your fingers, and check that it feels heavier
when its mark aligns.
a
10.Adjust:
1
2
a. Loosen the locknut "1".
b. Turn the adjusting screw "2" in or out until the
c. Hold the adjusting screw to prevent it from
Do not overtighten the locknut since this will
remove the free play between both push
rods.
11.Install:
NOTE:
Tighten the bolts diagonally.
b
5-36
Push lever position
G
MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM
marks are aligned.
moving and then tighten the locknut to speci-
fication.
ECA13820
CAUTION:
Locknut
8 Nm (0.8 m•kg, 5.8 ft•lb)
LLLLLLLLLLLLLLLLLLLLLLLLLLLLLLLL
Clutch cover "1"
G
Clutch cover bolt
10 Nm (1.0 m•kg, 7.2 ft•lb)
M6 × 25 mm bolt "2"
G
M6 × 35 mm bolt "3"
G
M6 × 50 mm bolt "4"
G
M6 × 50 mm bolt (with gasket)"5"
G
M6 × 55 mm bolt (with gasket)"6"
G
CLUTCH