Overview Embroidery Hoop Functions; Centering The Embroidery Hoop To The Needle; Moving The Hoop To The Back; Moving The Embroidery Arm To The Left - Bernina 700 Manual

Overview Embroidery hoop functions

1

Centering the embroidery hoop to the needle 4

2

Moving the hoop to the back

3

Moving the embroidery arm to the left

Centering the embroidery hoop to the needle
Relocating the embroidery hoop facilitates threading when the needle is close to the embroidery hoop.
> Touch the icon «Embroidery hoop display/Embroidery hoop selection».
> Touch the icon «Center the embroidery hoop to the needle» or
P
> Push the button «Center the embroidery hoop to the needle».
> Thread the upper thread (see page 39).
P
> Press the button «Start/Stop» to move the embroidery hoop back to the last position.
Moving the hoop to the back
To facilitate changing the bobbin, it is recommended to move the hoop to the back before threading. This
makes it easier to open the bobbin cover.
> Touch the icon «Embroidery hoop display/Embroidery hoop selection».
> Touch the icon «Move the hoop to the back» or
P
> Push the button «Move the hoop to the back».
> Thread the bobbin thread (see page 43).
P
> Push the button «Start/Stop» to move the embroidery hoop back to the last position. Pull the upper
thread if necessary.
Moving the embroidery arm to the left
> Touch the icon «Embroidery hoop display/Embroidery hoop selection».
> Remove the hoop.
0371485.0.04_2016-05_Manual_B700
1
2
3
4
5
6
Grid on/off
5 Motif center
6 Virtual positioning
Embroidery preparation
51