Troubleshooting - Electrolux EYL85066BT User Manual

9. TROUBLESHOOTING

WARNING!
Switch OFF the electricity at the mains supply and remove the circuit fuse before attempting
any fault nding inside the unit.
Problem/Symptom
Shower fail to
operate, no water
ow out.
Water too hot.
Water temperature
cycling hot/cool at
intervals.
Water too cool
or cold.
Cause
Interrupted power supply.
Unit malfunction.
Not enough water owing
through the shower.
Blockage in supply.
Increase in ambient
water temperature.
Heater cycling on
temperature limiter.
Too much ow.
Water pressure below
minimum required
(see rating label).
Reduction in ambient
water temperature.
Electrical malfunction.
Safety cut-out operated.
Action/Cure
Blown fuse or circuit breaker. Check
supply. Renew or reset fuse or circuit
breaker. If it fails again, consult a quali ed
electrician.
Check other appliances and if necessary,
contact local Electricity Supply Co. Have
unit checked. If it still fail to operate,
contact Electrolux Customer Service.
Increase ow rate via water ow controler.
Blocked showerhead -- clean or replace
blocked sprayplate in showerhead.
Check if stop valves are fully open. Check
if a blockage in the inlet lter.
Reduce the setting temperature via
temperature adjuster.
See 'Water too hot' causes and their
appropriate action/cures. If it continues
contact Electrolux Customer Service.
Reduce ow rate via water ow controler.
Is it water supply mains or tank fed?
If tank fed, replumb to mains water supply.
If mains fed, make sure that mains
stopvalve is fully open and that there are
no other restrictions in the supply while
shower is in use.
Fit pump to give minimum pressure (see
rating label). Electrolux Contact Customer
Service for advice.
Select a higher water temperature via
temperature adjuster.
Have unit checked by suitably quali ed
electrician or contact Electrolux Customer
Service.
Thermal safety cut-out device has
operated. Have the unit checked by a
suitably quali ed engineer or contact
Electrolux Customer Service.
ENGLISH 23