12
www.electrolux.com
Top right inlet entry
Bottom left inlet entry
Rear left inlet entry
Left inlet entry
Top left inlet entry
To mark the drilling position
Using the installation template supplied,
mark the positions of the three xing holes.
NOTE: Ensure that there are suf cent
lengths of supply pipe and electrical cable
to reach the connection points as shown
on the template.
Remove the installation template and drill
the xing holes (dimension). Insert the wall
plugs (supplied).
CAUTION!
Check if there is any buried pipes or
cables before drilling.
Screw the top xing screws into position
leaving the base of the screw head
protruding 6mm out from the wall.