Electrolux EYL85066BT User Manual page 19

6. When a smooth ow of water is obtained,
rotate the temperature control from Min to
Max several times to release any trapped air
within the unit.
7. Once ushing out has been completed,
stop the water ow by pressing the On/off
button.
8. Fit the showerhead to the exible hose and
place in the showerhead holder(Fig.17).
Fig. 17
The shower is now ready for normal operation.
6.3
Daily use
Make sure the commissioning procedure
has been carried out.
To start the shower
Press the On/off button and water will ow.
To stop the shower
Press the On/off button again and water
will cease to ow.
When not using the shower unit, insolate
the unit from main circuit via the double
pole switch.
WARNING!
If restarting immediately after stopping,
be aware that a slug of hot water will
be expelled for the rst few seconds.
To use the temperature adjuster
The temperature adjuster can be rotated
within 300° and the temperature can be
set from 30°C to 46°C.
To run in cold water, just rotate the
adjuster fully anti-clockwise to the minimum
position " ". The shower will stop heating
and the temperature indicator will show the
actual temperature of the water.
NOTE: It will take a few seconds for the
temperature to stabilise after changing the
setting temperature.
To adjust the water ow
The water ow can be adjusted by the water
ow controler. The water ow controler can
be rotated within 300°.
-To increase the water ow turn the water
ow controler clockwisely.
-To decrease the water ow turn the water
ow controler anti-clockwisely.
NOTE:
Adjusting the water ow will not change
the water temperature setting, but it may
need some time for the water to be stable
again.
It is advisable that the showering
temperature is satisfactory by testing with
your hand before stepping under the
showerhead. There will always be a time
delay of a few seconds between selecting
a temperature and the water reaching the
stable temperature for that ow rate.
ENGLISH 19