Electrolux EYL85066BT User Manual page 15

5.4 Fixing the front cover
1. Before xing the front cover to the shower,
tighten the 3 screws to x the shower on the
wall rmly.
2. Adjust the spline spindle and the control
knob to the correct position before replacing
the cover Fig. 7a, 7b show the correct pline
spindle and the control knob position.
3. Reassemble the water inlet cover Fig. 8a
and reconnect the cable Fig. 8b.
Fig. 8a
Fig. 7a
Fig. 7b
Fig. 8b
4. Check to ensure that the wiring is not
trapped and replace the cover squarely to
the backplate and guide into position so that
the knobs locate correctly into the splined
spindles. Should any dif culty arise, recheck
the points above.
5. While applying slight pressure to the cover,
secure in position with the retaining screws.
6. Once you place the front cover on the
back cover properly x the front cover with
the 4 screws.
Stabiliser valve
Water ow position
ENGLISH
1. Turn the stabiliser valve
spindle fully clockwise
until resistance is felt.
2.
Turn the water ow
controler fully clockwise
to the Minimum
15