Maintenance - Electrolux EYL85066BT User Manual

7. MAINTENANCE

WARNING!
Before maintenance work, you must
switch off the power at the isolating switch.
Do not remove the front panel.
Do not spurt water to the unit.
7.1 General cleaning
You can use a clean cloth to wipe the front
panel.
While cleaning the front panel
Do not use brushes, emery paper or
burnishes to clean the unit because it
may cause damages.
Do not use a chemically treated cloth or
duster to clean the unit.
Do not use benzine, thinner, polishing
powder or similar solvents for cleaning.
These may cause the plastic surface to
crack or deform.
7.2 Clean the water inlet lter
It is recommended that the lter is
periodically cleaned, in order to maintain the
performance of the shower.
Before removing the lter, turn off the main
water supply of the shower.
To remove the lter see Fig. 18 below.
Fig. 18
Inspect the 'O' ring for damage when the
When cleaning the lter, DO NOT use a
sharp object, as it will cause damage. It is
preferable to use an old toothbrush or similar.
Reassemble the lter after you clean it. While
reassembling the lter:
NOTE:
Full commissioning procedure will need to
be performed after cleaning of the lter - see
page 14 for information on commissioning
procedure.
O-ring
Filter assembly
lter cap is removed.
Make sure that the sealing 'O' ring is in
place.
DO NOT over tighten the lter cap on
reassembly.
ENGLISH 21