1.PREPARATION
3
Align the side guides with the edges of the paper, and then push back the lever.
1
Up to 100 sheets of plain paper (80 g/m
the stacked paper does not exceed the indicators of the side guides. If paper other than plain is
used, set it one sheet at a time.
Fan the paper well before loading it on the bypass tray, otherwise multiple feeding could occur.
Be careful not to cut your fingers.
Do not push the paper forcibly into the entrance of the bypass feeder, otherwise it could cause a
paper misfeed.
Flatten curled paper before loading it on the bypass tray.
If paper remains on the bypass tray when loading additional paper on it, release the lever, then
remove all the paper, and then load it again.
When you use paper longer than the bypass tray size, pull out the paper holder from the tray.
Depending on its condition, paper may not be fed for bypass copying. In this case, turn over the
paper and place it again as shown in the figure.
2
2
or 20 lb. Bond) can be loaded. Be sure that the height of
1 PREPARATION
Preparation 2 - Loading Paper
31