Table of Contents
Advertisement
1.PREPARATION
9. Paper Feed Pedestal (optional)
Use the Paper Feed Pedestal to add one drawer. The Drawer Module can be installed in this device. A
maximum of 550 sheets (80 g/m2 or 20 lb. Bond) can be placed in one go.
10.Drawer Module (optional)
Use this to add one more drawer to the Paper Feed Pedestal (optional). A maximum of 550 sheets (80 g/
m2 or 20 lb. Bond) can be placed in one go.
11.Receiving tray
12.Paper exit stopper
Stops large paper from sliding out of the receiving tray.
13.Power switch
Turns the power ON or OFF.
P.18 "Preparation 1 - Turning Power ON"
14.AC-IN terminal (rear)
Connect the power cable supplied with the equipment.
15.TEL (optional)
Connect to an external telephone.
For details on how to use the Fax functions, see the following manual.
Fax Guide
16.Network interface connector
Use this connector when connecting this equipment to a network.
17.USB terminal (4-pin)
Connect to your PC using a commercially available USB cable.
Use a USB2.0 Hi-Speed certified cable: USB cable supporting the USB2.0 Hi-Speed mode (480
Mbps of transfer speed) certified by the USB Implementers Forum.
Connect the equipment with a PC directly by the USB cable. When it is connected with a PC via a
USB hub, the equipment may not be recognized.
18.LINE (optional)
Connect to the public switched telephone network.
For details on how to use the Fax functions, see the following manual.
Fax Guide
19.Scanning area
The data of originals transported from Reversing Automatic Document Feeder are scanned here.
P.218 "Regular Cleaning"
20.Original scale
Confirm the size of an original placed on the original glass.
1 PREPARATION
Components
11
Advertisement
Table of Contents
