Table of Contents
Advertisement
Control Panel
Use the Control Panel to turn the projector lamp on and off, change the display source for the
projector, open Notebook software, and adjust the volume of the internal sound system.
Lamp On
On LED
Volume Down
VCR/DVD Player
The Lamp On and Lamp Off Buttons
In normal operation, you should keep the projector powered up all the time. However, to conserve the
lamp, put the projector into standby mode at the end of your session (or at the end of the day). In
standby mode, the projector lamp is powered down, but the projector itself remains on.
To put the projector into standby mode, press the Lamp Off button on the Control Panel. For the next
three minutes, the lamp is in a reversible standby mode in which the screen appears black, even
though the projector lamp remains on, allowing you to quickly restore the display by pressing any
button on the Control Panel.
After three minutes, the lamp cools down for 60 seconds and then powers off. You can skip this
three-minute reversible standby period by pressing and holding the Lamp Off button for three
seconds. To power up the projector lamp, press the Lamp On button.
For the current status of the lamp, check the LEDs beside the Lamp On and Lamp Off buttons, and
then check the table below.
On LED
Flashing moderately quickly
Solid
Flashing occasionally (short
flashes followed by long
pauses)
6
Volume Up
Internal Computer
Notebook
Off LED
Software
The Control Panel
Off LED
Lamp Status
Off
Lamp is powering up. During this 60-second
period, the Lamp On and Off buttons are
disabled.
Off
Lamp is fully powered up.
On
Lamp is off.
2000i-DVX Installation Guide
Guest Laptop
Lamp Off
Advertisement
Table of Contents
