Putting The 2000I On Standby - Smart Technologies 2000i-DVX Installation Manual

Putting the 2000i on Standby

For normal operation, you don't need to power down the computer or the projector at the end of a
session or at the end of the day. Just log off the computer (for security) and then turn off the projector
lamp (to conserve its life) by pressing the Lamp Off button on the Control Panel.
NOTE: If you won't use the 2000i for an extended period of time, you should power down the
computer and the projector.
To put the 2000i on standby
1. Log off by selecting Start > Shut Down.
NOTE: Logging off enhances system security. It also gives users a consistent initial interface –
the system logon screen – when they power up the projector lamp.
2. Press the Lamp Off button to put the projector into reversible standby mode for three minutes.
While the screen appears black, the projector lamp remains on so you can immediately restore
the image (if necessary) by pressing any button on the Control Panel. After three minutes, the
lamp powers off and cools down for 60 seconds.
To skip the three-minute reversible period, press and hold the Lamp Off button for three
seconds. Release the button and the lamp powers off and enters a 60-second cooldown period.
Perform this procedure at the end of a meeting or presentation and at the end of the day. If you
prefer, you can also shut down the computer. However, we recommend simply logging off rather
than powering down the computer.
To power down the projector (if unused for an extended period)
1. Log off (as described above) and power down the computer.
2. Press the Lamp Off button on the Control Panel.
The Off LED indicator blinks rapidly for three minutes (reversible standby), and then slowly for
approximately 60 seconds while the lamp cools down. When the lamp is off, the On LED indicator
blinks very slowly.
OR
Press and hold the Lamp Off button for three seconds. The lamp immediately powers down and
enters a 60-second cooldown period.
3. When the cooling fan stops, flip the power switch on the back of the projector.
4. Disconnect the 2000i power cable from the wall power outlet.
30
Lamp Off Button on the Control Panel
2000i-DVX Installation Guide
Lamp Off