Attachment On Request - Honda hf2622 Original Instruction

PROBLEM
12. The cutting means do not engage
13. Uneven cut and poor grass
collection
14. Unusual vibrations while working
15. With the engine running, the machi-
ne does not move when the drive pedal
is pressed
( for hydrostatic drive models)
16. Mulching operation cannot be
performed
( for HF2417HM• - HF2417HT•
HF2622H♦• models)
If problems continue after having carried out these operations, contact your Dealer.
WARNING!
Do not take on complicated repair work if you don't have the necessary equipment and the technical knowledge.
The guarantee is automatically revoked and the manufacturer declines all responsibility for any repairs which are badly done.
9. ATTACHMENTS ON REQUEST
1. DISCHARGE GUARD KIT
80609-VK1-003
Used instead of the grass catcher
when the cuttings are not col-
lected.
2. TOWING HITCH
80596-VK1-003
For towing a small trailer.
EN 26
LIKELY CAUSE
– belt loosened
– problems in the electromagnetic clutch
– cutting-means assembly is not parallel to
the ground
– inefficient cutting means
– forward speed too high compared to height
of grass ( 5.4.5)
– clogged discharge chute
– cutting deck is full of grass
– the cutting means are imbalanced
– cutting means loose
– fixing bolts loose
– disengage lever in positon «B» (
– The lever does not move (inconvenience
caused by an accumulation of grass in the
discharge chute or cutting-means assem-
bly)
– shutter does not close to the correct
position
1
1
2
2
– turn the adjusting nut (
– contact your Dealer
– check the tyre pressures (
– reset the cutting-means assembly alignment (
– check that the cutting means is fitted properly (
– sharpen or replace the cutting means (
– check the belt tension and the cutting means engagement
lever cable ( 6.3.3)
– reduce the forward speed and/or raise the height of the
cutting-means assembly.
– wait for the grass to dry
– remove the grass catcher and empty the discharge chute
( 5.4.7)
– – clean the cutting-means assembly (
– balance or replace the damaged cutting means (
– check that the cutting means are firmly fitted (
– check and tighten all the fixing bolts of the engine and frame
4.33) – put into position «A»
– remove the material accumulated in the discharge chute or
cutting-means assembly
– contact your Dealer
3. MULCHING PLUG AND
CUTTING MEANS
HF2315: 80597-VK1-003
HF2417HB: 06805-VK1-A10
It finely chops the grass cuttings
and leaves them on the lawn,
instead of collecting them in the
grass-catcher.
WARNING!
For your safety, it is strictly prohibited to
install any other attachment than the ones listed above and
especially designed for your machine model and type.
SOLUTION
6.3.3)
5.3.2)
6.3.2)
6.3.1)
6.3.1)
5.4.10)
6.3.1)
6.3.1)
1
2
3