Table of Contents
Advertisement
Available languages
Available languages
5.6 TRANSPORT POSITION
WARNING!
If the machine must be transported on a
truck or trailer, use ramps with suitable resistance, width
and length. Load the machine with the engine switched off,
without a driver and pushed by an adequate number of pe-
ople. During transport, lower the cutting-means assembly,
engage the parking brake and fasten the machine securely
to the hauling device with ropes or chains.
5.7 ADVICE ON HOW TO OBTAIN A GOOD CUT
1. To keep a lawn green and soft with a good appearance, it should
be cut regularly and without damaging the grass.
2.
It is always better to cut the grass when dry.
3. The cutting means must be in good condition and well sharp-
ened so that the grass is cut straight without a ragged edge that
leads to yellowing at the ends.
4. The engine must run at full speed, both to ensure a sharp cut of
the grass and to get the necessary thrust to push the cuttings
through the discharge chute.
5. The frequency of mowing should be in relation to the rate of
growth of the grass, which should not be left to grow too much
between one cut and the next.
6. During hot and dry periods, the grass should be cut a little higher
to prevent the gro und from drying out.
7. If the grass is very tall, it should be cut twice in a twenty-four hour
period. The first time with the cutting means at maximum cutting
height, possibly reducing the cutting width and the second cut
at the height desired.
8. The appearance of the lawn will improve if you alternate the cut-
ting in both directions.
9. If the discharge chute tends to get blocked with grass, you
should reduce the forward speed as it may be too high for the
condition of the grass. If the problem persists, the probable
causes are either badly sharpened cutting means or deformed
fins.
10. Be very careful when mowing near bushes or kerbs as these
could distort the horizontal position of the cutting-means assem-
bly and damage its edge as well as the cutting means.
5.8 SUMMARY OF THE MAIN OPERATIONS TO BE CARRIED
OUT IN VARIOUS CONDITIONS OF USE
To ...
You will need to ...
rass-catcher.
Ensure that all the conditions allowing
Start the engine (
5.4.1)
starting are met, and then turn the key.
Movethe accelerator;
Goforward (
5.4.2)
push the pedal right
HF2315SB•
down, engage the gear (
4.22)
and then gradually release the
pedal;
press the drive pedal
HF2•••H
•
◆
forward (
4.32);
Reduce the engine speed and press
Brake or stop (
5.4.3)
the brake pedal.
Stop the machine;
Reverse (
5.4.4)
put into neutral (N), push
HF2315SB•
the pedal right down, engage reverse, (
4.22) and then gradually release the
pedal;
press the drive pedal in
HF2•••H
•
◆
reverse; (
4.33)
Fit the grass catcher or discharge
Cut the grass (
5.4.5)
guard, adjust the height of the anti-
chipping wheels and the throttle; en-
gage the cutting means and adjust the
cutting height.
push the pedal right
HF2315SB•
down, engage the gear (
4.22) and
then gradually release the pedal;
press the drive pedal
HF2•••H
••
◆
forward (
4.32);
Stop moving forwards, disengage the
Empty the grass catcher (
5.4.6)
cutting means and use the control lever
to tip up the grass catcher.
Remove all grass cuttings clogging the
Operate the cutting height adjusting
discharge chute (
5.4.7)
lever several times to shake
and free the discharge chute.
Stop moving forwards, disengage the
cutting means and turn off the engine.
Remove the grass catcher and clean
the chute.
Excluded:
Engage “Mulching” (
5.4.8)
and
HF24••
••
HF26••
••
◊
◊
This accessory
HF2315
•
◆
◊
(optional) must be mounted as
shown in the relative instructions.
“Mulching” is engaged
HF2417HB•
or disengaged via an appropriate le-
ver (2) (
4.10)
Disengage the cutting means and re-
End mowing (
5.4.8)
duce the engine speed.
Reduce the engine speed, wait a few
Stop the engine (
5.4.9)
seconds, and turn the key.
Engage the parking brake, remove the
Store the machine (
5.4.10)
key and, if necessary, wash the ma-
chine, the inside of the cutting-means
assembly, the discharge chute and the
grass catcher.
17 EN
Hide quick links:
Advertisement
Chapters
Table of Contents
