Honda hf2622 Original Instruction page 7

3.2 GRASS-CATCHER ASSEMBLY
A) Join the upper part of the frame (1) to
the front component (2) using the supplied
screws and nuts (3) as shown. Fit the two
rubber caps (4) into the holes in the tube
of front frame (2).
HF2•••HT•
B) Before fully tightening the nuts (3),
insert the two supports (5) between the
plates of the upper frame (1) with the roll-
ers turned inwards. Fasten them with the
screws and nuts (6) and then fully tighten
the nuts (3).
C-D) Attach the two side elements (7), using the screws and nuts
(8 and 9) as shown. Fit the two rubber caps (10) into the holes in
the two side elements (7).
E) Insert the frame in the canvas cover (11) making sure it is cor-
rectly positioned on the base perimeter. Hook the plastic profiles (12)
onto the frame tubes with the aid of a screw-driver (13).
HF2•••SB• HF2•••HM•
F) Place the plate (14) between the
canvas and the lower part of the frame's
right side element (7a), lining up the
holes.
F) Attach the stiffening bar (15) under the
frame with screws and nuts (16) keeping
the flat part turned towards the canvas.
G) Using the six screws (18), attach the
cover (17) to the frame's upper part (1).
HF2•••SB• HF2•••HM•
H) Insert the emptying lever (19) in its
position and put in the limit stop screw
(20) with its nut (21).
3.3 GRASS-CATCHER SUPPORT ASSEMBLY
Fit the two brackets (1) on the rear plate
(2), using for each bracket three screws
(3) which are supplied, as shown, with-
out fully tightening the nuts (4).
The supports (1) must be mounted so
that the wings (1a) are turned inwards.
Hook the upper part of the grass-
catcher frame (5) onto the bra ckets and
centre it up with the rear plate (2).
Adjust the position of the two brackets
(1) to the stop (6) so that, when turn-
ing the grass-catcher frame, the pin (7)
slots into the seat (8) correctly.
Check again that the frame (5) is prop-
erly centred with the rear plate (2)
and that it rotates correctly, as shown
above, and then fully tighten the screws (3) and the nuts (4).
3.4 ASSEMBLING THE LEVERS FOR TIPPING
THE GRASS-CATCHER
HF2•••HT•
Position the lever axle (1) in the
notch of the two plates (2) and at-
tach them on the internal side of the
grass-catcher supports (3), using the
included screws (4) in the sequence
shown.
Connect the end of the rod (5) of the
lifting piston to the lever (6) with the
pin (7) and attach the two snap rings
(8).
Before attaching the grass-catcher
to its supports, make sure that the tipping lever moves properly.
3.5 REMOVAL OF THE STOP FROM THE HOOKING PAWL
OF THE GRASS-CATCHER
For transport purposes, the pawl (1)
hooking the grass-catcher is held onto the
rear plate by a stop (2). This stop must be
removed before fitting the grass-catcher
brackets, and is not to be subsequently
used.
7 EN