Accessories On Request - Honda HF2315 Original Instruction

PROBLEM
12. The blades do not engage
13. Uneven cut and poor grass
collection
14. Unusual vibrations while working
15. With the engine running, the ma-
chine does not move when the drive
pedal is pressed
( for hydrostatic drive models)
If problems continue after having carried out these operations, contact your Dealer.
WARNING!
Do not take on complicated repair work if you don't have the necessary equipment and the technical knowledge.
The guarantee is automatically revoked and the manufacturer declines all responsibility for any repairs which are badly done.
9. ACCESSORIES (OPTIONAL)
1. STONE-GUARD KIT
80092-VK1-003
For use in place of the grass-cat -
cher when the cuttings are not to
be collected.
2. TOWING HITCH
80596-VK1-003
For towing a small trailer.
3. MULCHING PLUG
HF2315: 80597-VK1-003
HF2417: 06805-VK1-A10
HF2620: 06805-VK1-B10
It finely chops the grass cuttings
and leaves them on the lawn, in-
stead of collecting them in the
grass-catcher.
EN 24
LIKELY CAUSE
– belt loosened
– problems in the electromagnetic clutch
– cutting deck not parallel to the ground
– blade cutting badly
– forward speed too high compared to height
of grass ( 5.4.5)
– collector channel is blocked
– cutting deck full of grass
– the blades are imbalanced
– blades loose
– fixing bolts loose
– disengage lever in positon «B» (
– turn the adjusting nut (
– contact your Dealer
– check the tyre pressures (
– re-align the cutting deck to the ground (
– check that the blades are fitted properly (
– sharpen or fit new blades (
– check the tension of the belt and control cable of the blade
engagement lever (
– reduce forward speed and/or raise the cutting deck
– wait for the grass to dry
– remove the grass-catcher and empty the collector channel
( 5.4.7)
– clean the cutting deck(
– balance or replace the damaged blades (
– check that the blades are firmly fitted (
(remember the left-hand thread of the right hand blade)
– check and tighten all the fixing bolts of the engine and
frame
4.33) – put into position «A»
WARNING!
For your safety, it is strictly prohibited to in-
stall any other attachment than the ones listed above and es-
pecially designed for your machine model and type.
SOLUTION
6.3.3)
5.3.2)
6.3.2)
6.3.1)
6.3.1)
6.3.3)
5.4.10)
6.3.1)
6.3.1)