EMC CelerraNS-120 Installation Manual page 5

Installation steps:

1. Review and complete the Celerra worksheet,

prepared for the installation of your Celerra NS-120.

About 20 minutes.

2. If your Celerra NS-120 is to be installed in a customer-supplied rack, use this document to unpack

the system from the mini-rack shipping container, remove the reusable rails, and install the system

in your available rack.

About 40 minutes.

Note: If your Celerra NS-120 system arrived at your site in a pre-installed cabinet and is

previously cabled, verify the cabling before you begin the use of your system.

Cable your system according to the instructions and illustrations contained in this document.

Ensure that all of your cables are seated securely.

About 45 minutes.

3. When you install your Celerra NS-120, use the Celerra Startup Assistant (CSA) to pre-conﬁ gure

your system. The latest version of the CSA can be downloaded from the Celerra Tools section on

®.

Powerlink

. The CSA is also on the Celerra Applications & Tools CD.

About 15 minutes.

4. Register your system with the service provider. If you do not register your system now, using the

Celerra Startup Assistant, your request for support from your service provider will be delayed.

You can also register your Celerra NS-120 by downloading the Registration Wizard on

About 5 minutes.

Implementation step:

After you have registered your Celerra NS-120 system, you must conﬁ gure the system for

production. You can use the Provisioning Wizard in the CSA, one of the several pre-packaged

implementation conﬁ gurations based on common usages, or your own implementation using

Celerra Manager to conﬁ gure your system. At the end of each one of these conﬁ gurations,

your system will be ready for production.

Note: If your Celerra NS-120 system has the Fibre Channel-enabled option use

Navisphere

Manager to provision storage for use by other Hosts.

For more information, refer to Celerra Tools on http://Powerlink.EMC.com

Installation overview steps

pages

31-32,

and verify that the site is properly

Powerlink.