Advertisement
Install components, latches, and bezels
1. Starting with the bottom component fi rst, install each component.
2. Fully tighten the retention screws and ensure that each component is installed securely.
3. Install the needed latches, as you install the components.
4. After all the components and latches are in place, snap on the bezels.
Disk-array enclosure (DAE)
2 bracket screws each side
Front
A and B sides
bezel bracket
2 screws per side
Control Station (CS)
Standby power supply (SPS)
Storage processor (SP)
Front
Rail catch
1 screw per side
Blade enclosure
1U latch, 2 screws each side
Right front side
Inside
Install the lower
screw first with 2 screws
on each side.
Inside
The indentation goes
toward the inside of
the rack.
For more information, refer to Celerra Tools on http://Powerlink.EMC.com
5
4
3
2
1
Press
Snap on bezels
11
Install the bottom component first.
Ensure that each component
is secure before you install the
component above it.
Press to install the bezel,
then release.
CNS-001461MOD NEW
Advertisement
