Exerpeutic Magnetic Treadmill 4010.6-120116 Owner's Manual page 16

Adjusting the Running Belt
1. The running belt is initially set and adjusted at the factory. However it may
come loose during transportation and/or during use. After prolonged use, the
belt will begin to stretch out.
2. If the running belt begins to shift to either left or right side, the user can stand
on the Anti-slip Pads and hold the handlebar with both hands. Then use your
right or left foot to run on the side of the running belt that is opposite to the
direction of the slip.
3. If the belt begins to slip to the left use your right foot on the right side. You
should see the belt start to correct itself by moving back towards the center.
4. However, if the running belt is still shifting away from center, use the 5mm Allen
Wrench provided and turn the left or right Rear Roller Adjustment Bolt 1/2 turn
in a clockwise direction (turn the same side bolt that matches the direction of
the slip).
Then try running on the center of the running belt again. If the running belt is still
shifting away from center, turn the same Rear Adjustment Bolt another 1/4 turn in
the clockwise direction. You should see the belt start to correct itself by moving
back towards the center.
Repeat this procedure until the running belt is centered.
If the running belt is slipping during use, then use the 5mm Allen Wrench provided
and
turn both the left and right rear roller adjustment bolts 1/4 turn in the clockwise
direction. You should now run on the running belt to determine if the running belt
is still slipping. Repeating the above procedure until the running belt is not
slipping.
ADJUSTMENTS
14