eXact Micro 20 Instruction Manual page 16

Using eXact
®
1
2
3
Follow the steps to 'SELECT CUSTOMER' & 'CONNECT DEVICE VIA BLUETOOTH' before
proceeding (see page 8).
4
5
6
7
16
reagent Standard liquid test procedure
Used for Cyanuric Acid
TURN METER ON
Press the
show all annunciators, then the current
by the last reading.
SELECT GROUP AND MENU
Press and re–press the
Then, press and re–press the
parameter (see chart on page 10–11).
RINSE CELL AND FILL WITH SAMPLE
Rinse the CELL at least 3 times with the water sample you
will be testing (rinsing minimizes the potential for cross–
contamination from a previous test). Finally, fill the CELL to
capacity with the water sample.
ZERO METER*
Cover the CELL with the CELL COVER and press the
button. The cursor will move across the display followed by a
display reading of 0.00 PPM. Tilt the meter to discard about
0.2mL water in order to leave room for liquid reagent. Sample
is ready for testing.
ADD DROPS
Remove the CELL COVER and, using the selected bottle of
reagent, add the required drops (see chart on pages 10–11)
and cover the CELL with the CELL COVER. Precaution:
Ensure that the bottle is straight when dispensing drops.
PRESS READ & MIX
Press
time, turn the meter upside down repetitively. When the timer
displays '1', place the Micro 20 on a flat surface. Wait for
count– up time.
RECORD RESULT
The cursor will move across the display while the meter
prepares to measure the sample. Record the value displayed
for the respective parameter. This value is automatically stored
in its MENU and if using the eXact iDip
saved in the app's 'HISTORY'.
*For best accuracy, when testing outdoors in sunlight, place cap over cell cover
and Fluoride
1 2
button to power the meter on; the display will
button to Select your group.
and a 20 second countdown begins. During this
selection, followed
button to select the test
app, the result will be
®