About The Sample Cell (Built–In 4 Ml) - eXact Micro 20 Instruction Manual

About the Sample Cell (built–in 4 mL)
The built–in Sample Cell (CELL) is transparent plastic and, when filled to the top, contains 4 mL. The
sturdy CELL design will last for over 20,000 readings. Scratches on the CELL will not interfere or
compromise the accuracy of the readings because of its fixed position. For best accuracy, rinse cell
with clean water immediately after a test is completed. Do not use solvents, such as acetone, to clean
the cell. When the CELL becomes stained or cloudy from repeated testing, or when the meter does
not blank when you press the ZERO/ON button, the cell needs to be cleaned. Clean as follows: Fill cell
with clean water and move the Cell cleaning brush up–and–down and back–and–forth along the walls
of the cell. Afterwards, rinse the cell and the meter is ready for use again. Cleaning the cell regularly is
especially recommended after you run a test that is using turbidity or precipitation chemistry for analysis
(Calcium Hardness, Sulfate, Chloride, and Cyanuric Acid).
How to install or replace "AAA" batteries
Batteries are not included. The meter requires (4) AAA in order to function.
Unscrew the O–ring sealed battery cover counter–clockwise. Use proper sized pliers if necessary.
1
Do not disturb the sealing O–ring.
Remove the used batteries and install 4 new AAA batteries following the diagram for correct polarity
2
(see diagram). We recommend high quality AAA alkaline batteries be used.
Replace the battery cover. Be sure to tighten the cover securely. This is necessary for meter to
3
ensure it is waterproof.
Dispose of the used batteries in accordance with your local regulations.
4
Press button to confirm the meter turns on.
5
The meter is now ready for operation.
Meter will not work if battery orientation is incorrect.
2–year limited warranty
Registration of your eXact
activate the warranty. The eXact
workmanship for a period of two (2) years from the date of purchase by the customer. ITS will repair
or replace any part of the product which is deemed to be faulty or otherwise defective. The non–
transferable warranty does not cover product damage caused by abuse (such as crushing a tablet in
the cell) or improper use. If the meter is faulty or otherwise defective contact ITS by phone (+1–803–
329–9712 Ext. 0) or email (its@sensafe.com) to describe the problem and obtain a return authorization
form before returning the photometer to ITS. Damage caused by improper packing of the photometer for
return shipment to ITS will not be covered by the warranty. Customer is responsible for shipping charges
to ITS. ITS pays postage when photometer is returned to customer. A maximum processing fee of $75
will be charged for repair or replacement of non–registered photometers and damages not covered by
this warranty. Registration is available over the phone (+1–803–329–9712 Ext. 0) or on–line at http://
www.sensafe.com/micro/warranty/ (Personal data is kept confidential).
photometer must be received within 30 days from date of purchase to
®
photometer is warranted to be free from defects in materials and
®
13