Driving Data (Multifunction Display) - Skoda Citigo Owner's Manual

Operating the information system
Operating the multifunction display
Press (up or down) - Select data / Setting values
A
Press Show / confirm entry
B
Operating the MAXI DOT display
Press (up or down) - move to the selected menu
A
Hold (up or down) - display main menu
Press - confirm selected menu item
B

Driving data (multifunction display)


Introduction
This chapter contains information on the following subjects:
Information overview
Warning at excessive speeds
Memory
The driving data is displayed in the multifunction display when is ignition is
switched on.
If vehicles with MAXI DOTdisplay do not show the driving data after switching
on the ignition, select the menu item MFD in the main menu and confirm
» page 41, MAXI DOT display.
On vehicles with a MAXI DOT display, there is an option to fade out the units
and some of the information » page
Fig. 24
Buttons on the control lever
41, Menu item Settings.
Information overview
Overview of driving data (depending on the vehicle equipment).
Clock - current time is displayed.
Outside temperature - If the outside temperature drops below +4 °C, the tem-
perature indicator appears and a snowflake symbol  (display for low temper-
ature) flashes for a few seconds, then remains displayed together with the
outside temperature.
Driving time - Driving time since last clearing the memory.
Current fuel consumption - When the vehicle is stationary or moving slowly,
the fuel consumption is displayed in l/h (in models in some countries the fol-
lowing appears --,- km/l). With G-TEC vehicles the current consumption of the
fuel currently being used is displayed ( with regards to a stationary or slow
moving vehicle, the natural gas consumption is displayed in kg/h).
Average fuel consumption - Is calculated continuously since the last clearing
of the memory. After erasing the memory, no data will appear for the first 300
m driven. With G-TEC vehicles, the average consumption of fuel currently being
used is displayed.
Natural gas qualityThe details of the quality of natural gas are displayed as a
percentage of between 70% to 100%. The higher the value of natural gas, the
lower is the consumption.
Range - Drive distance in km which can be covered with the existing tank ca-
pacity and with the same driving style. If you drive more efficiently this value
can increase. With G-TEC vehicles the following details are displayed - Range
39
with natural gas / petrol.
40
Distance driven - Distance driven since the memory was last cleared.
40
Total distance travelled - Odometer
Average speed - Value constantly recalculated, for distance since last clearing
the memory. After erasing the memory, no data will appear for the first 300 m
driven.
Current Speed - Digital speedometer.
Coolant temperature - If the coolant temperature is in the range 70-120 °C,
the engine operating temperature has been reached. If the temperature is be-
low 70 ° C, high engine speeds and straining the engine should be avoided. If
the temperature is over 120 ° C, the warning light lights up the instrument
cluster » page 33.

39
Information system