Skoda Citigo Owner's Manual page 111

The tyre pressure monitoring function (hereinafter referred to as: the system)
monitors the tyre pressure while driving.
If the tyre inflation pressure changes, the warning light
strument cluster and an audible signal is
The system can only function properly if the tyres have the prescribed inflation
pressure and these pressure values are stored in the system.
WARNING
The general information relating to the use of assistance systems must
■
be observed » page 103, in section Introduction.
Having the correct tyre inflation pressure is always the driver's responsi-
■
bility. Tyre pressure should be checked regularly
The system cannot warn in case of very rapid tyre inflation pressure loss,
■
e.g. in case of sudden tyre damage.
Storing the tyre pressure values.

Read and observe on page 109 first.
Procedure for storing the tyre pressure values
›
Inflate all the tyres to the specified pressure.
›
Switch on the ignition.
›
Press down  » Fig. 130 on the button.
The warning light lights up in the instrument cluster.

An acoustic signal and the control indicator provide information about the
storage of the tyre pressure values.
›
Release  .
lights up in the in-

heard» page 34, .
» page 129.
Fig. 130
Key for storing the pressure val-
ues
Always save the tyre pressure values in the system if one of the following
events occurs.
▶
Change of tyre inflation pressure.
▶
Change one or more wheels.
▶
Change in position of a wheel on the vehicle.
▶
Illumination of the warning light
WARNING
Before storing the pressures, the tyres must be inflated to the specified in-
flation pressure » page 129. If the wrong pressure valuesare stored, the
system may not issue any warnings, even if the tyre pressure is too low.
CAUTION
Save the tyre pressure values every 10,000 km or 1x annually to ensure correct
system functioning.
in the instrument cluster.

Assist systems
109