Information System; Driver Information System - Skoda Citigo Owner's Manual

Hide thumbs Also See for Citigo:
Table of Contents

Advertisement

Information system

Driver information system

Introduction
This chapter contains information on the following subjects:
Display in the instrument cluster
Switching between the time and external temperature display
Setting the time in the instrument cluster
Trip counter
Recommended gear
Operating the information system
Display in the instrument cluster
Fig. 20 Display types: MAXI DOT / Segment displays
Depending on the vehicle's equipment, the information system uses the dis-
play in the instrument cluster to provide the following information
Time
Counter for distance travelled (trip)
Engaged gear / gear recommendation
Warning lights
Information messages
Service interval display
Multifunction display
External temperature display
Fuel
gauge» Fig. 17
on page 30.
Door alarm
Door, luggage compartment and bonnet alarm
When the door or luggage compartment / bonnet is open, a graphical warning
appears in theMAXI DOT display. An acoustic signal will also sound if you drive
the vehicle above 6 km/h when a door is open.
Switching between the time and external temperature display
only applies to the segment display (instrument cluster - variant 3).
37
Hold the key
C
37
display flashes.
37
Release the button.
38
Select the desired indication by pressing briefly.
38
Wait a few seconds until the selected indication stops flashing.
39
Setting the time in the instrument cluster
Fig. 21 Button in the instrument cluster: Variant 1 and 2/ Variant 3
The time can be adjusted with the ignition on.
Instrument cluster - Var. 1 and 2
» Fig.
20.
Press down button
The hour is set by repeatedly pressing button
Switch to the minutes by pressing button
The minutes are set by repeatedly pressing button
Confirm the value entered by pressing button
seconds. The setting is saved automatically (the value stops flashing).
In vehicles equipped with the instrument cluster-Var.1 display, it is also possi-
ble to set the Time in the time menu item
Instrument cluster - Var. 3
Hold the button
» Fig. 21
on page 37until the time/ external temperature
until» Fig.
21the hour flashes in the display.
A
B
.
A
A
» page
41, Menu item Settings.
» Fig.
21until the time display flashes.
C
.
.
B
again, or wait for around 5
37
Information system

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents