Skoda Citigo Owner's Manual page 74

WARNING
The blower should always be on to prevent the windows from misting.
■
Otherwise there is a risk of accident.
Under certain circumstances, air at a temperature of about 5 °C can flow
■
out of the vents when the cooling system is switched on.
Note
The air inlet in front of the windscreen must be free of e.g. ice, snow or
■
leaves to ensure that the heating and cooling system operates properly.
After switching on the cooling Condensation from the evaporator of the air
■
conditioning may drip down and form a puddle below the vehicle. This is not a
leak!
If the coolant temperature is too high, the cooling system is switched off to
■
ensure that the engine cools down.
Heating and manual air conditioning
Fig. 86 Heating Controls
Fig. 87 Controls of the air conditioning
72
Using the system

Read and observe on page 72 first.
Individual functions can be set or switched on by turning the control dial and
pressing the appropriate button
switched on, the indicator light in the button lights up.
Setting temperature
A
▶
Reduce the temperature /

Setting the fan speed (level 0: blower off, level 4: highest speed)
B
Set the direction of the air outlet
C
 Air flow to the windows
 Air flow to the upper body
 Air flow in the footwell
 Air flow to the windows and the footwell
Recirculated air mode
D
▶
 Turn on
▶
 Turn off
Switching the cooling system on/off

Information on the cooling system
After pressing the button  the indicator light on the button lights up, even if
not all the conditions for the cooling system have been met. The cooling sys-
tem starts to work as soon as the following conditions have been met
» page 71.
Note
In order to ensure adequate warmth and comfort, the operation of the air con-
ditioning may lead to an increase in the engine idle speed.
» Fig. 86 and » Fig. 87. When the function is
Increase the temperature

» page 74