Skoda Citigo Owner's Manual page 140

Description of the breakdown kit
Fig. 154 Description of the breakdown kit

Read and observe on page 137 first.
The kit is located in a box under the floor covering in the luggage compart-
ment.
Sticker with speed designation "max. 80 km/h"/"max. 50 mph"
1
Valve remover
2
Inflation hose with plug
3
12 volt cable connector
4
Tyre inflation pressure indicator
5
Screw for tyre pressure reduction
6
Air compressor (the layout of the controls may be different depending on
7
the type of air compressor delivered with the vehicle)
Tyre inflation hose
8
ON and OFF switch
9
Tyre inflator bottle with sealing agent
10
Replacement valve core
11
Note
The declaration of conformity is included with the air compressor or the log
folder.
138
Do-it-yourself
Preparing to use the breakdown kit

Read and observe on page 137 first.
For safety's sake, the following instructions must be observed before
undertaking a wheel repair on a road.
›
Park the vehicle as far as possible away from the traffic flow - choose a place
with a flat and firm surface.
›
Switch off the engine.
›
For vehicles with manual transmission select 1st gear.
›
For vehicles with automated transmission shift the lever to position D or R.
›
Firmly apply the handbrake.
›
Switch on the hazard warning lights and set up the warning triangle at the
prescribed distance.
›
Have all the occupants get out. While the repair is being carried out, the pas-
sengers should not stand on the road (instead they should remain behind a
crash barrier, for instance).
Sealing and inflating tyres

Read and observe on page 137 first.
Sealing
›
Unscrew the valve cap from the damaged tyre.
›
Insert the valve remover » Fig. 154
2
the valve insert fits into the slot of the valve remover.
›
Unscrew the valve insert and place it on a clean base (rag, paper etc.).
›
Forcefully shake bottle » Fig. 154
10
›
Firmly screw the inflation hose
on the bottle cap is pierced.
›
Remove the plug from the inflation hose
tyre valve.
›
Hold the bottle with the bottom facing upwards and fill all of the sealing
10
agent from the tyre inflator bottle into the tyre.
›
Remove the filler plug from the tyre valve.
›
Screw in the valve insert with the valve remover
Inflating
›
Screw the tyre inflation hose
8
valve.
›
For vehicles with manual transmission set the gearshift lever to the neutral
position.
on page 138 on the valve insert, so that
on page 138 several times.
onto the tyre inflater bottle
3
10
and insert the bottle onto the
3
.
2
» Fig. 154 on page 138 firmly onto the tyre
. The film
