Skoda Citigo Owner's Manual page 36

▶
Switch off the ignition, start the engine again and travel a short distance.
▶
If the warning light does not go out, obtain assistance from an authorised
dealer.
Disconnecting the vehicle battery
If the vehicle's battery has been disconnected and reconnected, the warning
light comes on after switching on the
The warning light should go out after driving a short distance.
If, after the motor is restarted and a short drive, the indicator light does not go
out, there is a system error.
▶
Seek help from a specialist garage.
Stability control (ESC) / Traction control (TCS)


Read and observe on page 32 first.
flashes – the ESC or TCS is currently active.

lights up – there is an ESC or TCS fault.

▶
Seek help from a specialist garage.
As the ESC operates in conjunction with the ABS, the ESC warning light will al-
so come on if the ABS system fails.
If the warning light comes on after starting the engine, the ESC or TCS may

have been switched off for technical reasons.
▶
Switch the ignition off and on again.
If the warning light does not illuminate after you switch the engine back on,

the ASR is fully functional again.
Disconnecting the vehicle battery
If the vehicle's battery has been disconnected and reconnected, the warning
light comes on after switching on the
The warning light should go out after driving a short distance.
If, after a short drive, the indicator light does not go out, there is a system er-
ror.
▶
Seek help from a specialist garage.
More information about the ESC system
TCS system » page 104, Traction control (TCS).
34
Using the system
ignition.

ignition.

» page 104, Stability Control (ESC) or
Anti-lock braking system (ABS)


Read and observe on page 32 first.
lights up – there is an ABS fault.

The vehicle will only be braked by the normal brake system without the ABS.
▶
Seek help from a specialist garage.
In the event of an ABS fault, the other braking and stabilization systems are
turned off » page 103, Braking and stabilisation systems .
WARNING
If the ABS warning light together with the indicator light
■ 
Braking system lights up, do not continue to drive! Seek help from a

specialist garage.
A fault to the ABS system or the braking system can increase the vehi-
■
cle's braking distance – risk of accident!


Read and observe on page 32 first.
Change of tyre pressure values
lights up - there was a pressure change in one of the tyres.

An audible signal sounds as a warning.
▶
Immediately reduce speed and avoid sudden steering and braking manoeu-
vres.
▶
Stop the vehicle, turn the ignition off and check the tyres and their inflation
pressures » page 129.
▶
Correct the tyre pressure if necessary or replace the affected wheel
» page 134 or use the repair kit
▶
Save the tyre pressure values in the system
System fault
flashes for approximately 1 minute and remains lit – there may be a fault in

the tyre pressure monitoring system.
▶
Stop the vehicle, turn the ignition off and start the engine again.
If the warning light flashes again after the engine has started, there is a

system error.

» page 137.
» page 109.
» page 32,
