Skoda Citigo Owner's Manual page 75

Climatronic (automatic air conditioning)
Fig. 88 Controls the Climatronic

Read and observe on page 72 first.
Individual functions can be set or switched on by pressing the corresponding
button » Fig. 88. When this function is switched on, the corresponding icon ap-
pears in the display.
Setting temperature
1
▶
Increase temperature /

Selected temperature
2
Temperature units (degrees Celsius / Fahrenheit)
3
Intensive air flow to the windscreen switched on
4
Recirculated air mode activated
5
Direction of air flow
6
Automatic operation of the air conditioning system is switched on
7
Cooling system activated
8
Set blower speed
9
Adjust the blower speed
10

▶
Increase speed
▶
 Reduce speed up to turning off the Climatronic
Interior temperature sensor
11
Switching on/off the intensive windscreen air flow - when this function

is switched on, the warning light illuminates in the button
Switch recirculation on/off » page 73

Switching the airflow to the windows on and off

Switching the airflow to the upper body on and off

reduce temperature

Switching the airflow to the footwell on and off

Switching automatic mode on

Switching the cooling system on/off

After the cooling system is switched off, only the ventilation function remains
active whereby the minimum temperature that can be reached is the outside
temperature.
Setting temperature
In the range between 16 °C to 29 °C, an automatic temperature control takes
place.
At a temperature setting below 16 ° C,  lights up in the temperature display,
the Climatronic functions with maximum cooling performance.
At a temperature setting above 29 °C,  lights up in the temperature display,
the Climatronic functions with maximum heating output.
CAUTION
Do not cover the interior temperature sensor
Climatronic could be affected.
Note
In order to ensure adequate thermal comfort, there may be an increase in en-
gine idle speed during operation of the Climatronic in some circumstances.
Climatronic - automatic operation

Read and observe on page 72 first.
The automatic mode is used in order to maintain a constant temperature and
to demist the windows in the interior of the car.
›
To switch on press thebutton. The display shows  (pos.
on page 73).
›
To turn off, press any button for the air distribution or change the blower
speed. However, temperature regulation is continued.
recirculation

Read and observe on page 72 first.
The recirculation mode prevents contaminated outside air getting into the in-
terior of the vehicle. In recirculated air mode air is sucked out of the interior of
the vehicle and then fed back into the interior.
» Fig. 88 - the function of the
11
» Fig. 88
7
73
Heating and ventilation
