Monitor Menu (M2); Multimonitor (M2.1) - Siemens bt300 Operator's Manual

Chapter 4 - Parameters and Menu Structure

Monitor Menu (M2)

Structure Parameter
P1.15 Ctrl. Place Auto
P1.16 Automatic Reset
P1.17 PID Mini-Wizard
P1.18 MultiPump Wizard
P1.19 Startup Wizard
P1.20 Fire Mode Wizard
P1.21 Bypass Wizard
Monitor Menu (M2)
The Siemens BT300 HVAC Drive allows you to monitor actual values, parameters, and signals as well as status
and measurements. Some of the monitored values are customizable.
Menu and Parameter Group

Multimonitor (M2.1)

Basic (M2.2)
Timer Functions (M2.3)
PID Controller 1 (M2.4)
PID Controller 2 (M2.5)
Multi-Pump (M2.6)
Fieldbus Data (M2.8)
Temp. Inputs (M2.9)
Multimonitor (M2.1)
On the Multi-Monitor page, you can collect nine values to monitor. The display fields can be changed by selecting
the display field to be changed with the
30 | 180
Siemens Industry, Inc.
Building Technologies
Unit ID
172 Start/Stop commands are given differently depending upon the control place.
This parameter defines whether the Start/Stop command is controlled by
digital inputs as defined in Control Signal 1 A (P3.5.1.1) and Control Signal 2
A (P3.5.1.2) in accordance with the I/O A Start/Stop Logic (P3.2.6) or if the
Start/Stop command is controlled by the Fieldbus that is in use.
Settings:
0 = I/O Control (control is from the physical I/O, PID control, or time channels)
1 = Fieldbus (control is from the configured fieldbus found in Ethernet or RS-
485 settings)
Also see
731 Enable parameter for the Automatic Reset function of the drive. This feature
is configured in the Parameters (M3) ... Automatic Reset (M3.10) menu.
Also see
1803 Enable parameter for the PID Mini-Wizard. This wizard assists with the
configuration of the PID Controller 1 using a single feedback and single
setpoint.
Enable parameter for the Multi-Pump Wizard. This wizard assists with the
configuration of the Multi-Pump function of the drive. The PID Mini Wizard will
precede this wizard.
1171 Enable parameter for the Startup Wizard. This wizard assist with the essential
information required for drive operation.
This wizard is automatically enabled after Restore Factory Defaults (P6.5.1) is
activated.
1672 Enable parameter for the Fire Mode Wizard.
1823 Enable parameter for the Bypass Wizard. This wizard can be activated during
the Startup Wizard.
Table 5: Monitor Menu.
Display of 9 monitored values.
Display of basic drive monitoring parameters.
Display of timer function specific monitoring parameters.
Display of PID Controller 1 specific monitoring parameters.
Display of PID Controller 2 specific monitoring parameters.
Display of Multi-Pump specific monitoring parameters.
Display of Mapped Fieldbus Data monitoring parameters.
Display of connected temperature inputs.
and arrow buttons, and then pressing the
Siemens BT300 HVAC Drive
Description
Menu Structure P3.2.1 .
Menu Structure P3.10.1
.
Description
button. Scroll
DPD01809
2016-06-07