Installing & Cleaning Hepa Filter; Troubleshooting - Vacmaster VK1530SIWDC-T 950204 Instructions Manual

Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam
sleeve fi lter. (fi g. 3)
2. Use a mild soap and water solution to wash foam sleeve fi lter and rinse with clean
water. (fig. 4)
3. Allow fi lter to air dry before installing and using again.
1 2
I
NSTALLING & CLEANING HEPA FILTER
Installing HEPA FILTER
1. Verify that the power cord is disconnected from the outlet. (fi g.1)
9
2. Unlock the fi lter door by lifting the lock tab UP to the unlocked position and pull
the door out. (fi g. 2 & 3)
3. Remove the HEPA fi lter cartridge from the vacuum. (fi g.4)
Cleaning HEPA Filter
4. Clean fi lter by brushing dirt off. For optimal performance a new fi lter is
recommended. (fi g.5)
5. Install the cleaned or new fi lter into place. (fi g. 6)
6. Insert the fi lter door tabs into the upper slots and lock the fi lter door into place.
(fi g. 7 & 8)
1 2
6 7
3 4 5
3 4 5
8
T
ROUBLESHOOTING
Symptom Possible Causes
1) No power supply.
2) Faulty power cord.
Vacuum will not
operate
3) Container full.
1) The PET cartridge
Dust comes out
fi lter or collection bag
from motor cover.
is missing or damaged.
1) There is a blockage in
Reduced
the nozzle or hose,
effi ciency and
or the container inlet.
motor/speed
Or dust fi lter blocked
vibration.
by fi ne dust.
Disposal Information
The appliance contains electric and electronic components and may not be
disposed of as household garbage. The local and currently applicable legislation
must be observed unconditionally.
Corrective Action
1) Check power supply – cord,
breakers, fuses.
2) Unplug and check the
power cord. If damaged,
have it repaired by a
professional.
3) Empty container.
1) Attach or replace PET
cartridge fi lter or collection
bag.
1) Check nozzle, hose and
container inlets for
blockage. Take off the fi lter
and clean it. Or install new
cartridge fi lter.