Switching On/Off; Dry Vacuum Operation - Vacmaster VK1530SIWDC-T 950204 Instructions Manual

S
WITCHING ON/OFF
A
A: Function switch ON/OFF switch
B: Outlet-socket
Connect the mains plug.
1. Switching on the vacuum cleaner:
Press
2.Switch on electrical appliance + vacuum
cleaner:
Press
Switch on electrical appliance.Only connect electrical appliances with a maximum
power rating of 2200W.Switching on the electrical appliance automatically switches
on the vacuum cleaner. Once the electrical appliance has been switched off, the
vacuum cleaner switches off following a time lapse.
3. Switching off the vacuum cleaner:
Press
D
RY-VACUUM OPERATION
WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION,
ENTITLED 'SAFETY INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN
AREAS WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR.
FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO; LIGHTER
FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE, ALCOHOL OR
B
AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO;
COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF HEALTH
HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
WARNING: DO NOT PLUG IN POWER CORD TO POWER OUTLET. MAKE SURE
PLUG IS DISCONNECTED BEFORE CHANGING AND CLEANING FILTERS.
1. Verify that the power cord is disconnected from the outlet. (fi g.1)
2. In order to prepare your vacuum for dry vacuuming, verify that the PET cartridge
fi lter is securely mounted.Make sure the fi lter is pushed in until it stops against the
power head. (fi g.2) (Your Wet/Dry Vac comes with the cartridge fi lter pre-installed,
if not see page 8 for installation instructions.)
3. Place fi lter retainer on top of PET cartridge fi lter and tighten down by turning the
retainer handle clockwise. (fi g.3)
4. Put the PRE cloth fi lter over the fi lter tray with the attached PET cartridge fi lter.
(fi g.4)
5. Optional, for improved dust fi ltering, fi t collection bag fl ange onto the inlet stub,
taking care not to damage the bag. (fi g.5)
6. Place the power head back on the container, and secure it in place
using the latches. (fi g.6)
OPERATING INSTRUCTIONS: DRY VACUUMING
7. Insert the locking end of the hose into the vacuum port and screw in place. Push
the required attachment onto the free end of the hose or extension. (fi g.7)
8. Plug in the power cord into the outlet. (fi g.8)
9. Turn the motor on by fl ipping the switch to the 'I' ON position. (fi g.9)
10. Once you have completed vacuuming, fl ip the switch to the 'O' OFF position and
unplug the power cord from the outlet.
0 = OFF
I = ON
II = ON
DO NOT USE COLLECTION BAG FOR LIQUID VACUUMING
6