Installing & Cleaning Hepa Filter; Troubleshooting - Vacmaster VMVK1520SIWC Manual

Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam
sleeve filter. (fig. 3)
2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean
water. (fig. 4)
3. Allow filter to air dry before installing and using again.
1 2
I
NStALLING & CLEANING HEPA FILtER
Installing HEpa FIlTEr
9 9
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Unlock the filter door by lifting the lock tab UP to the unlocked position and pull
the door out. (fig. 2 & 3)
3. Remove the HEPA filter cartridge from the vacuum. (fig.4)
Cleaning HEpa Filter
4. Clean filter by brushing dirt off. For optimal performance a new filter is
recommended. (fig.5)
5. Install the cleaned or new filter into place. (fig. 6)
6. Insert the filter door tabs into the upper slots and lock the filter door into place.
(fig. 7 & 8)
1 2
6 7
3 4 5
3 4 5
8
t
ROUBLESHOOtING
Symptom possible Causes
1) No power supply.
2) Faulty power cord.
Vacuum will not
operate
3) Container full.
1) The PET cartridge
Dust comes out
filter or collection bag
from motor cover.
is missing or damaged.
1) There is a blockage in
Reduced
the nozzle or hose,
efficiency and
or the container inlet.
motor/speed
Or dust filter blocked
vibration.
by fine dust.
Corrective action
1) Check power supply – cord,
breakers, fuses.
2) Unplug and check the
power cord. If damaged,
have it repaired by a
professional.
3) Empty container.
1) Attach or replace PET
cartridge filter or collection
bag.
1) Check nozzle, hose and
container inlets for
blockage. Take off the filter
and clean it. Or install new
cartridge filter.