Connecting To The Network; Connecting Power To The Unit - Paradyne HOTWIRE 7924 User Manual

Installing the Unit

Connecting to the Network

Connecting Power to the Unit

2-2
Procedure
1. Connect one end of the supplied 14 twisted-pair network cable into the rear
panel HDSL jack. Connect the other end to your HDSL network interface.
NOTE:
Do not use a flat VF network cable, as this may severely degrade the
performance of the termination unit. Use only twisted-pair network cable.
2. Connect a V.35 or DSX-1 interface cable into the appropriate connector on
the rear panel. Connect the other end to your V.35 or DSX-1 equipment.
HDSL
DSX-1-Compatible HotWire 7924 – Rear Panel
HDSL
V.35-Compatible HotWire 7924 – Rear Panel
As described in Chapter
on your power source (120 Vac, 230 Vac, or – 48 Vdc).
Your package may also include a country-specific adapter. To obtain information
on the various power cord adapters available, refer to
Service Information
on page A at the beginning of this User's Guide.
Plug the power transformer into an available 115 or 230 Vac power outlet, running
the power lead to the unit housing. Connect the power lead into the – 48 Vdc plug
on the rear panel.
August 1997
48 VDC
48 VDC
1, there are several options for power cords, depending
DS1
97-15356-01
V.35
97-15264
Warranty, Sales, and
7924-A2-GB20-20