Table of Contents
Advertisement
information can be reviewed if available. When the Controller Menu appears
it is available for programming and reviewing.
2.7 Turn Off the Handset
Select the TURN OFF icon using the
icon is highlighted, press
it will turn off automatically after 10 minutes.
10:00
10:00
MAIN MENU
3.
Initial communication
3.1 Setup Steps to Initiate Communication for the First Time
First, let the LEIT-2 controller sit out in bright light to harness light energy used
to power the controller. This will take about 30 minutes or less in direct
sunlight. Next, connect the 2 yellow-colored sensor wires on the LEIT-2
controller to signal to the controller that it is about to be programmed. Splice
the 2 yellow sensor wires together using waterproof connectors. This splice
will distinguish that the controller is ready to communicate with a LEIT RC2
handset. Connect to the controller via the handset RADIO UPLINK icon using
the default address.
3.2 Connecting to the LEIT-2 controller for the first time using the
LEIT RC2 handset
In the LEIT RC2 handset's main menu press and highlight the RADIO UPLINK
icon. Press
and the RADIO UPLINK screen will appear with default setup.
The description in this screen is: CONTROL ID: 00, DEFAULT SETUP with the
first Ø flashing.
Press
to connect to the controller. The ARE YOU SURE? screen will appear
with the Radio Uplink icon selected. Press
without an ID. After establishing communication, CONNECTED will appear
to turn off the handset. If the handset is left on,
10:00
TURN OFF
TURN OFF
TURN OFF
or
buttons. When the TURN OFF
to connect to the controller
13
Advertisement
Table of Contents
