Table of Contents
Advertisement
1.2 Battery charge outlets and recharging the battery
The LEIT RC2 contains a cell battery pack that is rechargeable using the
AC/DC wall mounting charger 120 or 220 VAC/60 h2, 12 VDC @150 mA. To
charge the LEIT RC2 handset, plug the wall mount charger into the wall and
connect the power connector into the side of the LEIT RC2 handset. The initial
charge takes approximately 8 hours. Do not disconnect the handset during the
initial charge. When in use, the handset should be charged daily for a few
hours as needed. If the handset is charged, you will see a charging icon and a
battery appear. The battery repeats a filling action, indicating that the battery
is charging. Once the battery is charged, it will stop the filling motion, and the
wording CHARGED will appear. A car charger model 30-851 is available, if
needed.
The LEIT RC2 handset is ready for setup and communication.
2.
Main Menu
The SETUP MENU screen allows the user to set the LEIT RC2 handset in just a
few steps. In going though these steps select the time format (AM/PM or 24
hour), then in SET TIME/DATE screen set the time and date. In HANDSET
SETUP assign Handset ID and Client ID for identification purposes when
linking to a LEIT-2 controller. After setup is complete, the handset it is ready
for communication.
2.1 Navigation Menu
After charging the handset, press
The DIG logo screen, a time/date screen, software version screen and then,
the MAIN MENU screen will appear.
Press
to enter the MAIN MENU screen.
2.2 Radio Uplink
The RADIO UPLINK screen allows the LEIT RC2 handset to link to a LEIT-2
SW V: 1.00.00
EE V: 1.00.00
10:00:00 AM
MONDAY
7/10/2006
TIME / DATE
VERSION
to navigate through the initial screens.
10:00
MAIN MENU
8
Advertisement
Table of Contents
