Copyright And Compliance - DIG LEIT RC2 Operating Instructions Manual

2-way radio remote control handset

Hide thumbs Also See for LEIT RC2:

Table of Contents

RC2inst:Layout 1

are each trademarks of DIG Corporation. Patent Pending

FCC, CE, IC, Canada and Australia compliance

To comply with FCC RF exposure compliance requirements, the antenna used for this

transmitter is installed to provide a separation distance of at least 8 inches (20 cm) from all

persons (not including hands, wrist, feet and ankles) and must not be co-located or operating

in conjunction with any other antenna or transmitter.

This device is required to comply with FCC RF exposure requirements for mobile and fixed

transmitting devices. This model transceiver generates and uses radio frequency energy. If not

installed and used in accordance with the manufacturer's instructions, it may cause

interference to radio and television reception.

CONTROLLER FCC ID: UJV-LEIT01 IC: 6694A-LEIT01

HANDSET FCC ID: UJV-LEIT02

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates

uses and can radiate radio frequency energy. If not installed and used in accordance with the

instructions, the remote may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult DIG technician for help.

Warning: the user should make no field changes or modifications to the LEIT-2 controller or

the LEIT RC2 handset. All adjustments and changes must be made at DIG's facility under the

specific guidelines suggested in our instruction manual. Any tampering or modification to the

equipment will void the users authority to operate the unit, render the equipment in violation

of FCC part 15 and will void the warranty.

4/28/08

7:51 AM

Copyright and Compliance

IC: 6694A-LEIT02

Page 5

Table of Contents