Black & Decker d984 Installation Manual page 71

GM-O984-EDK
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
If you already have a Power Supply installed, ensure it' s
OFF and will remain OFF.
Bring field wiring to last housing in the Drop.
Fan-out your cable breakout and lay it in the cable trough
for rightmost I/O module slot on housing.
Open the wire connectors by turning the recessed terminal
screws CCW.
Insert the field wires into the wire connectors and tighten
the terminal screws.
Repeat Steps (3) thru (5) for each slot in last housing.
Repeat Steps (1) thru (6) above for each housing in the
Drop.
Repeat Steps (1) thru (7) above for each remaining Drop
System Installation
57