Rackmounting - Black & Decker d984 Installation Manual

Table of Contents

Advertisement

Step 7
Ground all W802 power cables to each housing' s ground
point in the drop as shown in Figure 5-1 preceding. The
grounding lug requires a #lO machine screw.
Step
8
Repeat Steps (1) thru (7) above for all remaining RI/O
drops.
Rack Mounting
The H819 Module Housings can be mounted in a
1
g-inch standard (EIA) rack.
This requires installing a rack adaptor mounting flange kit. Figure 22 shows the
housing' s rack mounting dimensions.
The following hardware is required for rack mounting each housing:
o (1) Rack mounting adaptor kit which includes: a pair of rack mounting flanges;
(8) #8-32 Pan Head Machine Screws (supplied) to attach rack mount flanges to
ends of housing; (8) l/4 bolts (supplied) to attach flange kit to back of housing.
o (8) #lo-32,
Pan Head Machine Screws to mount the housing with flange adap-
tor to NEMA rack.
o (8) #lo-32
Flat Lock Nuts if mounting holes in rack' s side rails rails are not
threaded.
Other special mounting hardware may be required depending upon the installa-
tion site.
50
System Installation
GM-O984-EDK

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

E984K984-x8x controllers

Table of Contents