Verify Your Local I/O; Controller To Ibm Pc Programming Panel Software; Getting Plc Into Run Mode - Black & Decker d984 Installation Manual

Verify Your Local I/O
Finish your installation verification by configuring and I/O mapping your PLC and
then communicating with local I/O.
ET
Note Record Executive ID and version number from the panel soft-
ware status screen.
Step 1
Set your controller' s input power to OFF. Shut off auxiliary
power.
Step 2
Install a simple I/O module in Slot 2 of primary housing (a
8805 for example) and secure with captive screws.
Step 3
Re-power
Controller to IBM PC Programming Panel Software
Step 4 Connect PLC to panel via either Modbus Port
1
or Modbus
Plus.
Step 5
At your DOS prompt type CD\Modsoft then at the Modsoft
directory prompt (typically C:\MODSOFT>)type MODSOFT'
to execute the panel software.
Expert Step 5 assumes your panel software is available in your com-
puter. If it is not refer to the Modsoft Programmer User Manual GM-
MSFT-001 for the load procedure.
Getting PLC into RUN Mode
A new controller can not be RUN without providing some data about the configura-
tion in which it is to operate. Steps 6 through 11 provide a quick method to assure
that your new controller will RUN.
64
Step 6 Press the panel " Enter" key
(
J
)
to display the main menu.
System
Installation
GM-O984-EDK